LITTER-ROBOT 3 HANDBUCH Pdf-Herunterladen (2024)

FAQs

How to manually cycle Litter-Robot 3? ›

Press and Release: Pressing the Cycle Button starts the Litter-Robot cleaning cycle. In order to pause the cycle, press any button on the Control Panel during the Clean Cycle. Press Cycle once again to resume the cleaning cycle.

If there is too much litter in the globe, it can cause cycling issues (getting stuck during a cycle).

For one average-sized cat, you'll need to empty the waste drawer about once per week, and for two cats, twice every 7-10 days is typical. To change the drawer liner in Litter-Robot 3 (with or without Connect), simply pull out the drawer, unhook the edges of the liner, and dispose.

The only litter that won't work with the Litter-Robot 4 is anything strictly absorbent, non-clumping or loose-clumping. Common examples include wood pellet litter and pine-based litters. Then comes the tricky part: getting your cats to actually use the litter box.

Cleaning your Litter-Robot

It's important to do a basic globe cleaning every 1-3 months and a deep cleaning at least every 3 months. Over time, small clumps can accumulate within the internal pocket of the globe, which can contribute to weight-related errors.

We recommend up to 4 indoor cats per single Litter-Robot; however, we do have customers with more cats using a single unit. As a rule of thumb, one cat using Litter-Robot 3 requires that the drawer be emptied once per week; two cats, twice per week; three cats, every other day, and so on.

It is possible that your unit could be overfilled with litter. The unit will dump any excess litter above the line during the cycle process. Please ensure your litter is filled at least 1/4in below the fill line.

Check for obstructions blocking the drawer full indicator (DFI) sensors. There are two sensors inside the base, above where the waste drawer would sit. Debris, such as dust or cat fur, can interfere with the DFI sensor. This can cause the unit to inaccurately trigger a drawer-full indication.

The magnets are located in the gear track that runs around the whole globe. Slowly move your magnet over the gear track. Standing in front of the globe opening, you should feel magnets near the 1 o'clock and 5 o'clock positions.

Press the Reset or Empty button to abort the cycle and return the Globe to the Home position. How it works: The Litter-Robot is ready for use when the Globe is at the Home position and the blue light on the Control Panel is on.

How do you force litter robot 4 to cycle? ›

While the Globe is in Home position with the blue Light Bar on, press the Empty button to start an Empty cycle. During an Empty cycle, press the Cycle, Reset, Empty, or Connect button to pause the cycle. Press the Cycle button to resume the cycle.